PDA

View Full Version : Whoops... accidental explode


HybridAWD
06-28-2006, 08:39 AM
I accidently exploded my border... how can I get it back to showing the proper information? I might just re-insert it.
dave
06-28-2006, 10:27 AM
ctrl-z :)
HybridAWD
06-28-2006, 10:57 AM
ctrl-z :)
I got zoom out of that
Colby
06-28-2006, 11:10 AM
keep doing it untill your Attributes come back
HybridAWD
06-29-2006, 08:29 AM
Is it possible to modify the current border I have so I can cut off a certain line from plotting with the drawing?

What I did was setup a custom bored, but forgot to make this line a different layer and then cut it off from printing. So now it is just part of the border. I would sure hate to have to go reload every border. :cry:
Colby
06-29-2006, 09:38 AM
lookup the command REFEDIT.

BUT BE VERY CAREFUL ON HOW YOU USE IT!
dave
06-29-2006, 09:54 AM
can you fix the dwg file, save it, and then do a global block update in Bentley? Just a thought.
Packin31
06-29-2006, 10:09 AM
HybridAWD,

Open your custom border and change the line you want to be on the different layer. Once you have done that go back into the P&ID and under the P&ID-TOOL/Maintenance you will see Refresh Border. That should refresh the border with your layer change.

FYI,
If you move attributes around in the block this will also update. Not like straight AutoCAD where they lock in place.
PlantWorker
07-10-2006, 12:47 AM
a tip : If you want to switch to another border, just delete the existing one, and insert a new one with command (bordins "A1") where A1 cooresponds with a A1BORD.dwg in your sym-folder