Equipment Couplers

[HybridAWD]

When I try and place a coupling, it shows up as the letter C vs. the actualy rectangular coupling. Where can I change the setting to make it show the graphic of the rectangle?

P&ID... --> Equipment... --> Coupling (the piece on the lower right hand side of the two pieces shown if you arent using expert mode).

[Aplant Monkey]

I might be staing the obvious but are you trying to put a coupling in the middle of the vessel? If so then the "C" style is correct. the square version will only display if you select the side of the vessel, thereby showing the coupling in profile.

[HybridAWD]

I might be staing the obvious but are you trying to put a coupling in the middle of the vessel? If so then the "C" style is correct. the square version will only display if you select the side of the vessel, thereby showing the coupling in profile.

Yeah it's when I am try to place it on the side. Does it being a general piece of equipment effect how it displays? What I am showing the coupling on is a piece of equipment I generated, then just made it generic.