nipper
08-22-2006, 05:12 PM
Hi Everybody
I have just made a few modifications to lines previously issused for construction. I have used "Assign Weld ID" and "Assign Spool Number" to retain the same weld numbers and spool numbers.
When i generate isometrics through isogen on those lines i get a duplication of the weld id's. I get a circle with the weld id and a box with the weld id pointing to each weld. Is there some switch i need to turn off when i am using the re-assign weld id tool.
Regards
I have just made a few modifications to lines previously issused for construction. I have used "Assign Weld ID" and "Assign Spool Number" to retain the same weld numbers and spool numbers.
When i generate isometrics through isogen on those lines i get a duplication of the weld id's. I get a circle with the weld id and a box with the weld id pointing to each weld. Is there some switch i need to turn off when i am using the re-assign weld id tool.
Regards