Support?

[Bingo]

How are you deal with support in AutoPLANT?

[dave]

You mean Technical support?

[Bingo]

the pipe's supports.

[dave]

I know our people use the structural package bingo.

[Bingo]

I think it is a good method, but the structural's supports do not show in iso drawing.How can you deal with?Did you just create orthedrawing, do not create ISO?

[AplantAdmin]

Bingo

Autoplant comes with supports in the piping package. If you need them to show in the isogen created isos, then you need to set up user created blocks for the supports. Isogen puts in a genaric block for it supports. Basicly the same one for all. it does not show supports on supports, but does label them as such and produces them in the BOM. You could use a support index to call them off if you like.