Reducer Error

[HybridAWD]

ERROR bad argument type: lentityp nil

Help?

[dave]

I don' think that error is limited to the reducer. I get it too occasionally, usually when trying to make an assembly. The other day when I got it, I had a type type mismatch and had to change the custom dir path for the drawing. That's when I run through the usual suspects like:

movexdpts
asiregenall
save
audit
check custom dir / standards path...

[aarti.vij]

This happens typically when AT_VIEWS are corrupt. Two possible solution
A) replace the Schema.mdb and Process.MDB of the affected project.
B) You can open the two databases in plain Access and run Compress and repair.