Save as....problem after using PID

[petrjiricek]

Hallo Everyone !

I am should be one problem.
At PID is function "Save as" disabled, it is correct.
But after using PID, I start single Autocad and this function
"Save as" is still disable.
Command line was write unknown command.

Pls Help

Petr

[Rijkwerd]

And the autoPLANT system is not running?

[TurnerSM]

This is because you have not change AutoCAD profiles.

You are still using an AutoPLANT profile, where Save As is disabled.

From the Tools pulldown, choose Options. On the far right-hand tab, you will find Profiles. The best best will most likely be the <<Unnamed rofile>>. This should be an out-of-the-box native AutoCAD profile.

This behavior comes from the way AutoCAD works. Unless a specific profile name is provided to AutoCAD at launch via a command line switch, it launches with the last active profile.

[BearLeader67]

If you rename your AutoCAD <<Unnamed profile>> profile to master then the switch for a shortcut would be "C:\Program Files\AutoCAD 2008\acad.exe" /p master