Error Creating New Component

[kkopp2005]

Good Day,

I am trying to create a new component and getting an error. Below are the steps and the error message. Any help would be great.

1. Created a copy of PID1.dwg and renamed it PID99.dwg.
2. Copied the new component to a box.
3. Clicked chg/set name and named the component.
4. Clicked block from block manager menu, clicked inside box of new component and got an unhandled exception error.

Error: Unhandled Exception C0000005 (Access Violation Reading 0x0000)
at address 0h

Thanks!

[Packin31]

Did you try to create a new block in the origianl PID1?

Do you receive the same error in that Drawing?

[Aplant Monkey]

that would be my exact question as well Tom. Why did you not just use the orig PID1.dwg. what is the reason for creating the copy?

[PeterJ]

did you switch on the slide creation ? That causes this error in XM

[kkopp2005]

I followed the directions found on a example sheet in the sym folder. The slide creation is on and in it creates the dwg file even thought there is an error. I haven't checked the slb file to see if a slide was created. I will keep you updated.

Thanks.