AutoLine Break issue

[HybridAWD]

When I use the Autoline Break command, it will delete the vertical line completely.

If there is a valve above the horizontal line, it will delete the line up to that point. If the line below the horizontal drops down, then turns, it will delete it to that point as well.

Has anyone else experienced this issue?

[HybridAWD]

Ok, not only that now, but when I try and annotate the line... it acts like it does, but the annotation is way off the drawing. It seems like this drawing has been moved.

[HybridAWD]

when I try to save the drawing I get this:

Adding URL Xdata Attachments 44 of 703.

Coincident with first point

Specify point on positive portion of X-axis <0'-1",-0'-8 9/16",0'-0">: 0,0,0

Specify point on positive-Y portion of the UCS XY plane <-0'-1",-0'-8
9/16",0'-0">:

Command:
Adding URL Xdata Attachments 566 of 703.; error: An error has occurred inside
the *error* functionFunction cancelled

[Data Wrangler]

Quick check for you - make sure your UCS is set to World. I would also check that all your polylines are heavy.

Derek

[Data Wrangler]

We have also gotten that co-incident error when someone brings a 3d object into a P&ID...

Derek

[HybridAWD]

UCS is on world, I'll check the Polylines now. Also, when I have the drawing in extents, it wont save, if im zoomed in some, it will allow me to save.... this is truely odd.

[HybridAWD]

polylines are fine.

[HybridAWD]

nevermind, not computer specific

[PeterJ]

try turning of your osnaps before breaking