How to deal with Jacketed Pipe

[wuzhongbo]

If anybody can tell me how to deal with Jacketed Pipe with Piping?

[andymorris]

Run the main pipe and the jacket pipe as two separate lines. Unfortunately, you will get two ISOGEN isometrics but this is the only way I can think of tackling this issue.

[Bundsbaek]

How about using isolation and then explain the legend on the iso. This could be combined with a few principle drawings explaining how the jacket is made. You could do the same using tracing instead if you like depending on what combinations you demand.
Hop that could give you some ideas
Regards
Jakob

[AplantAdmin]

Or you can just create a new line in your piping spec and change the long desc. to include jacketed or any description you need. Then it will show up in your BOM.