Kall747
02-03-2010, 07:38 AM
Does anyone know the trick to make a control point to move with a pump/tank when not inserting the control point on a node?
I have inserted a control point using pinpoint where the suction and the discharge would meet, but when moving the piece of equipment the control point stays put and the piece of equipment will move
Using Version SP3D 2009
2 years experience with Piping / Strutural / Equipment / Drawing Manager / Smartsketch / Hangers and Supports
Let me know if you have any questions also. Thanks B)
I have inserted a control point using pinpoint where the suction and the discharge would meet, but when moving the piece of equipment the control point stays put and the piece of equipment will move
Using Version SP3D 2009
2 years experience with Piping / Strutural / Equipment / Drawing Manager / Smartsketch / Hangers and Supports
Let me know if you have any questions also. Thanks B)