Isogen Bleed Ring Draw Issue

[AK_Dvisr]

Our bleed rings are showing a tap weld dot at the center in isogen, and the attached nipple draws half way into the BR. We are using the (default?) slip ring (SR) skey for lack of a better one. We didn't have this problem where I worked before, so we're hoping there is a simple fix.
thanks-jh

[awerning]

The short answer is that you will need to edit the symbols file (.asc) with Bentley's symbol editor and modify the skey symbol for the bleed ring. We just made it a simple box (without the ugly solid "circle" type thing on one side) and then set the tap points to be on the edge rather than the center. I would go into more detail at the moment, but I am crunched at work right now and then I am off for two weeks. Hopefully someone else will chime in with more details. Have you edited symbols before? Do you know how to launch the symbol editor?

[AK_Dvisr]

Thanks Aaron, we've dabbled with the symbol editor, and TKM sent me a link to Joel's post with good directions-Thanks Joel & Tom, you folks know some stuff! :)
-jamey

[tkmashl]

I don't know much, I am just lucky to know folks that do :)