andersun
02-10-2010, 10:03 PM
Sorry if this was asked and answered already, but my search turn up nothing.
I need to maintain connectivity of a line which used a flex hose to connect the same line, one section has a 5 degree slope to the other. the lines are in the same plane and elevation.
In the config.ini file I changed the following
Max_Slope_Tol = 8.5
MAX_FLANGEDSLOPE_TOL = 8.254
MAX_MISCSLOPE_TOL = 8.254
I'm still not able to connect the flex hose.
am I working in the correct area?
did I miss something?
can this even be done?
I need to maintain connectivity of a line which used a flex hose to connect the same line, one section has a 5 degree slope to the other. the lines are in the same plane and elevation.
In the config.ini file I changed the following
Max_Slope_Tol = 8.5
MAX_FLANGEDSLOPE_TOL = 8.254
MAX_MISCSLOPE_TOL = 8.254
I'm still not able to connect the flex hose.
am I working in the correct area?
did I miss something?
can this even be done?