Error running reports

[dave]

I have a project restored from another office into our office. I am trying to run some reports but all the reports minus the line list ask me to edit > save the reports before continuing. I do this and get the same error when trying to run the report again. I check the SmartplantPID.log file and see this...



Error in SmartPlantPID - described as: Report template: Battery Limit Summary.xls
Error in SmartPlantPID - described as: No view name in current DataPile: SubSystem
Error in SmartPlantPID - described as: No view name in current DataPile: PlantSystem
Error in SmartPlantPID - described as: No view name in current DataPile: SubSystem
Error in SmartPlantPID - described as: No view name in current DataPile: PlantSystem
Error in SmartPlantPID - described as: SPReport::RunReport; Error -->

all the paths are correct and the linked template path has been fixed in the drawing. Not sure what to do now.

[Patrick_Aps]

Here are some idea's, but they are all wild guesses

When you edited, did you go all the way to the define button to add a certain data field again ?
I suppose there are no differences in the RDB of the past and the current location ?
After editing, try to run the report only for the current drawing from the SPPID drawing interface
I that works, then try it tor run from the EDE.
Could a difference in the EDE config (what you see as columns in the EDE) be the cause ?

Strip down a copy of the report to one column (itemtag or SP_ID) and see if that runs.
If so, add a few coulmns until you find the problem or until the whole report works.

So, I quess you have a lot you can do now.
Sure hope it starts working again