SPPID 2007 - problems after install repair

[dave]

Since the corrupted installs / repairs last week we have been having trouble with the following...

· When placing OPC’s – data will populate through the OPC. It used to throw an inconsistency. He would like it to again.


· When placing reducers, Plant Group Name is resetting itself to the drawing default. I believe this is a new problem.


· When connecting two lines eg. 1” to 2” – the line will not throw in an inconsistency but will populate one of the values to the connecting line.

[Patrick_Aps]

All this behaviour should be rule based. check the connection to the rules.rul
Try editing a rule (small documented changed) to save the rules completely
and see if the new rule is happening.
what about the filtes needed for the rules ?

[louchesse]

also check that the symble authoring tool is set correctly