Stress Iso

[Aplant Monkey]

I am trying to set up a stress iso config. I basically need what I have with my Final set up so I have copied all the files from the final settings over to the stress folder and repathed the files properly. I do not need a BOM on my stress iso so I did not include the mld file.

When I run my iso all I am getting is a .dxf file in the directory but no dwg. I have it set to auto convert the dxf into a dwg but it doesn't seem to want to work.

Any thoughts as to what I may have over looked

[Aplant Monkey]

ok with the help of the humble Ken Fauver (aka kf) I have got this working now.

When setting up a Stress Iso be sure to do the following:

1. Suppress the BOM under option 23
2. make sure the .fls file has all the proper paths set up and that they are pointing to the Stress section rather than the final if you have copied it over.
3. remove the .mld path from the fls as you will not need it.
4. the one that got me ... be sure to set option 71 on the first page of the Option file to the correct backing sheet style. if using a smart dwg be sure it is saved to as least a version 2004 or earlier. If using the dxf option be sure to save it as an R12 dxf. Ensure the fls path is set to correctly select the proper backing sheet.

tks to kf for the help.

b