Help with Navisworks Plugin

[milic.srdjan]

Halo to all...

I have problem with Navisworks Navigator Plugin in Autodesk Plant 3D....

when I try to run this on icon or with command

>NWNAVIGATOR Plant 3D say that "command is unknown"....

I have install Navisworks Menage, because I wish to use clash system in Plant 3D

This is from Plant 3D help file

"Opens Navisworks in a new window.

Access Methods

Ribbon: Home tab Plugin panel Navisworks Navigator
Command entry: nwnavigator
Summary

The Navisworks Navigator window displays your 3D model while you are building it. In the Navisworks window, you can check for potential interferences.
"

I hope that someone have some ideas about this

Thanks in advance

Milic Srdjan
"

[Yo-mama]

SO the problem you are having is on the Plant 3D side? If so I assume you have loaded Navigator after you loaded Plant 3D? Then you loaded the NW cui using cuiload in P3D to get the toolbar?

[milic.srdjan]

Yes, Sir....You are right...

But I only load NavisWork export plug in, and when in try to use Navisworks Navigator those not work, and when I try to use Navisworks export Plant 3D collapse system...

This Navis Navigator work through Navis Menage system or not....I do not understand that part...

[Yo-mama]

The image you actually see inside of AutoCad in the fly out for Navisworks is a somewhat different application from the full blown stand alone version. So you have only loaded the plug in and not the actual application? If that is the case you need to load the software as that is what the command you are typing in is trying to launch. The Plug in is really just telling the graphics how to display in NW based off your P3D model. I hope this helps.