Update Work Area - does it work?

[Admin Newby]

In AP 3D, v8.6.1, load the Piping module, then navigate to "Drawing Production > Update Work Area". Nothing happens. How can I update my .nwd file?

[AplantAdmin]

you can't, you must create a new nwd file from explorer.

if you are talking about updating your model file then, when you are in the work area setup, make sure you save your changes, then push done. it should reload any change you have done.

If it does not do this, then go into your xrefs, remove them all, then go back to your workarea and reload.