LouisCho
10-28-2011, 08:02 AM
Hi again
I need a Victaulic No19 (45 elbow adapter to NPT connection) and there is no such component in the victaulic catalog. I was going to make one myself by copying the No.11 45 elbow. I know the geomery will not be the same because the threaded end is longer than the coupling side but it is an end of line and I don't need the exact end position of the component.
My question is what end code should I use. On END CONDITION 1 I got IGM (the end code already specified for the No.11 elbow) but what to choose for the END CONDITION 2? I check the ENDCODES.INI file and there is 2 identical threaded ends options, SCM and PCM. Wich one should I use?
[SCM]
Name = SCM
Description = Threaded Male End
Engagement_Type = Male
EL = THD_ENG_B; THD_ENG_R; THD_ENG_M
OD = PIPE_OD_M; PIPE_OD_R; PIPE_OD_B
[PCM]
Name = PCM
Description = Threaded Male End
Engagement_Type = Male
EL = THD_ENG_B; THD_ENG_R; THD_ENG_M
OD = PIPE_OD_M; PIPE_OD_R; PIPE_OD_B
Thanks
I need a Victaulic No19 (45 elbow adapter to NPT connection) and there is no such component in the victaulic catalog. I was going to make one myself by copying the No.11 45 elbow. I know the geomery will not be the same because the threaded end is longer than the coupling side but it is an end of line and I don't need the exact end position of the component.
My question is what end code should I use. On END CONDITION 1 I got IGM (the end code already specified for the No.11 elbow) but what to choose for the END CONDITION 2? I check the ENDCODES.INI file and there is 2 identical threaded ends options, SCM and PCM. Wich one should I use?
[SCM]
Name = SCM
Description = Threaded Male End
Engagement_Type = Male
EL = THD_ENG_B; THD_ENG_R; THD_ENG_M
OD = PIPE_OD_M; PIPE_OD_R; PIPE_OD_B
[PCM]
Name = PCM
Description = Threaded Male End
Engagement_Type = Male
EL = THD_ENG_B; THD_ENG_R; THD_ENG_M
OD = PIPE_OD_M; PIPE_OD_R; PIPE_OD_B
Thanks